Straight from the manufacturer's own manual.* Every number shows its page.* If we don't know, we say we don't know.*
GARAGE JOB ENGINE™ * 5W-AI

2015 GMC Canyon Specs: Oil Capacity, Fluids, Maintenance Schedule & Fuse Box

Figures for the 2015 GMC Canyon, copied from GMC’s own owner’s manual. Every one links to the manual page it came from.

From the manufacturer’s manuals. Every figure here is copied from the manufacturer's own manual, with a link to the page it came from. Where a manual is unclear or contradicts itself, we leave the figure out.

Engines in this manual: 2.5L L4, 3.6L V6. Figures that differ by engine say which engine they are for.

Fluids & capacities

All engines

Engine Oil

Use only engine oil meeting the dexos1™specification of the proper SAE viscosity grade. Look for the dexos1 approved logo for GM approved engine oil. See Engine Oil on page 10-9.

Applies to: Engine Oil

Source: 2015 GMC Canyon Owner Manual, page 11-13

2.5L L4

3.6L V6

Maintenance schedule

Normal service schedule

Use this for ordinary driving.

ServiceWhen
Replace engine air cleaner filter. (2)

Source: 2015 GMC Canyon Owner Manual, page 11-6

Every 45,000 mi(72,000 km)
Replace passenger compartment air filter. (1)

Source: 2015 GMC Canyon Owner Manual, page 11-6

Every 22,500 mi(36,000 km)
Rotate tires and perform Required Services. Check engine oil level and oil life percentage. Change engine oil and filter, if needed.

Source: 2015 GMC Canyon Owner Manual, page 11-6

Every 7,500 mi(12,000 km)

Severe service schedule

Use this if you tow, idle a lot, drive short trips in the cold, or run in dust.

ServiceWhen
Change automatic transmission fluid and filter.

Source: 2015 GMC Canyon Owner Manual, page 11-8

Every 45,000 mi(72,000 km)
Replace engine air cleaner filter. (2)

Source: 2015 GMC Canyon Owner Manual, page 11-8

Every 45,000 mi(72,000 km)
Replace passenger compartment air filter. (1)

Source: 2015 GMC Canyon Owner Manual, page 11-8

Every 22,500 mi(36,000 km)
Rotate tires and perform Required Services. Check engine oil level and oil life percentage. Change engine oil and filter, if needed.

Source: 2015 GMC Canyon Owner Manual, page 11-8

Every 7,500 mi(12,000 km)

Oil life & reset procedures

Engine oil life system reset

Before you start

  • Reset the system whenever the engine oil is changed so that the system can calculate the next engine oil change.
  • Turn the ignition to ON/RUN with the engine off.

Steps

  1. Display OIL LIFE REMAINING on the DIC. See Driver Information Center (DIC) (Base Level) on page 5-27 or Driver Information Center (DIC) (Uplevel) on page 5-29. If the vehicle does not have DIC buttons, the vehicle must be in P (Park) to access this display.
  2. Press and hold the V button on the DIC, or the SET/CLR button on the turn signal lever if the vehicle does not have DIC buttons, for several seconds. The oil life will change to 100%.
  3. Display OIL LIFE REMAINING on the DIC. If the display shows 100%, the system is reset.

You’ll know it worked: The oil life will change to 100%.

Source: 2015 GMC Canyon Owner Manual, page 10-12

Fuse box locations & fuse chart

Engine Compartment Fuse Block

Where to find it

Engine Compartment Fuse Block The engine compartment fuse block is in the engine compartment, on the driver side of the vehicle.

Lift the cover to access the fuse block.

Source: 2015 GMC Canyon Owner Manual, page 10-34

Instrument Panel Fuse Block

Where to find it

Instrument Panel Fuse Block The instrument panel fuse block is behind the passenger side cowl side trim panel.

Remove the plastic nut at the front of the cover, then pull the cover away from the trim panel to access the fuse block.

Source: 2015 GMC Canyon Owner Manual, page 10-38

All GMC repair jobs →

Other GMC Canyon years