Cooling System
2.1 qt
2 L
Applies to: Heater
Owner’s manual specs
2016 Chevrolet Spark Specs: Oil Capacity, Fluids & Maintenance Schedule
Figures for the 2016 Chevrolet Spark, copied from Chevrolet’s own owner’s manual. Every one links to the manual page it came from.
From the manufacturer’s manuals. Every figure here is copied from the manufacturer's own manual, with a link to the page it came from. Where a manual is unclear or contradicts itself, we leave the figure out.
Fluids & capacities
Cooling System
2.5 qt
2.4 L
Applies to: Power Electronics
Cooling System
5 qt
4.8 L
Cooling System
6.6 qt
6.2 L
Applies to: High Voltage Battery
Engine Coolant
50/50 mixture of clean, drinkable water and use only DEX-COOL® Coolant. See Engine Coolant 0 218.
Applies to: Engine Coolant
Engine Oil
Engine oil meeting the dexos1™specification of the proper SAE viscosity grade. ACDelco dexos1 Synthetic Blend is recommended. See Engine Oil 0 212.
Applies to: Engine Oil
Engine Oil with Filter
4.2 qt
4 L
Applies to: with filter
Transmission - Automatic
ACDelco CVT Fluid (Part No. 19260800, in Canada 19299096).
Applies to: Transmission - Automatic
Vehicle Coolant Circuits
50/50 mixture of deionized water and use only DEX-COOL® coolant.
Applies to: Vehicle Coolant Circuits
Maintenance schedule
Normal service schedule
Use this for ordinary driving.
| Service | When |
|---|---|
| Replace engine air cleaner filter. (3) | Every 45,000 mi(72,000 km) |
| Replace passenger compartment air filter. (1) | Every 22,500 mi(36,000 km) |
| Rotate tires and perform Required Services. Check engine oil level and oil life percentage. Change engine oil and filter, if needed. | Every 7,500 mi(12,000 km) |
Severe service schedule
Use this if you tow, idle a lot, drive short trips in the cold, or run in dust.
| Service | When |
|---|---|
| Replace engine air cleaner filter. (3) | Every 45,000 mi(72,000 km) |
| Replace passenger compartment air filter. (1) | Every 22,500 mi(36,000 km) |
| Rotate tires and perform Required Services. Check engine oil level and oil life percentage. Change engine oil and filter, if needed. | Every 7,500 mi(12,000 km) |
Oil life & reset procedures
Engine oil life system reset
Before you start
- Reset the system whenever the engine oil is changed so that the system can calculate the next engine oil change.
- Turn the ignition to ON/RUN with the engine off.
Steps
- Press the MENU button to show Remaining Oil Life on the display. This display shows an estimate of the oil's remaining useful life. If 99% is displayed, that means that 99% of the current oil life remains.
- To reset the engine oil life system, press the SET/CLR button while the oil life display is active. After a few seconds, the oil life will be reset to 100%. Be careful not to reset the oil life display accidentally at any time other than after the oil is changed. It cannot be reset accurately.
- Press the SET/CLR button to reset the oil life at 100%.
- Turn the ignition to LOCK/OFF.
You’ll know it worked: The system is reset when the CHANGE ENGINE OIL SOON message is off and the REMAINING OIL LIFE 100% message is displayed.
Not on this page
- Fuse box locations & fuse chart: The manual gives different answers by configuration, so we've left them out.